hi guys and gals
i haven't been here for a while...caught up in life i guess...
OK i have bought a 3.8 and 4t65e trans-axle for my trike build..will be rear engine(most of weight just in front of rear axle) this drive train came out of 1998 Pontiac grand prix and i have the factory cradle will use it i think as starting point we'll see.. will be using 1 3/4 inch Dom (11gauge) tubing for main frame tubing..i'm planning on home built leading link front end 40-45 degree neck,...8.5-9 foot wheel base...i have been researching this build and could not find any info on it so I'll party on!! , but I'm open to any input/advice if you have any... will post some pics. in near future...mike
i haven't been here for a while...caught up in life i guess...
OK i have bought a 3.8 and 4t65e trans-axle for my trike build..will be rear engine(most of weight just in front of rear axle) this drive train came out of 1998 Pontiac grand prix and i have the factory cradle will use it i think as starting point we'll see.. will be using 1 3/4 inch Dom (11gauge) tubing for main frame tubing..i'm planning on home built leading link front end 40-45 degree neck,...8.5-9 foot wheel base...i have been researching this build and could not find any info on it so I'll party on!! , but I'm open to any input/advice if you have any... will post some pics. in near future...mike