I just purchased two key fobs FCC ID: E4EG8DJ. I currently have one that works. I have read numerous procedures and still am not sure if you start steps 1 - 6 original or the new ones (unprogrammed).
1. Insert key into the ignition and turn it to the ON position.
2. Aim the remote at the trunk within 4 seconds press the RELEASE button.
3. Turn the ignition to the OFF position.
4. REPEAT steps 1-3 TWO
more times (do not remove the key just turn it in the igntion)
5. Turn the key to the ON position, aim the remote at the trunk and press the RELEASE button. DO NOT
TURN IGNITION OFF
6. Aim the same remote at the trunk within 4 seconds press the RELEASE
button.
7. Repeat step 6 for any other remotes you wish to program. If no further remotes are being
programmed proceed to step 8. (you can program 3 remotes)
8. Turn the ignition to the OFF position. Programming is now complete.
Thank you
ljs