Good evening
I have a question about how the float pins on the rotors are configured
should they be float pin with 2 spring washers then pushed through hole
and then washer and c-clip, or should they be float pin pushed through
hole and then 2 spring washers and washer and c-clip. I was driving
around a parking lot when I heard a pop from the front end.
went and did my shopping and came out and drove away hearing
another pop so I slowly drove home and checked out the front end
and found one of the float pins had broken and then just fell out
. what exactly is the right config for the float pins.
Thanx
Dragon