just bought a 2017 Tri Glide .. I need to move the driver floor boards out and if possible .. Everyone says they don't have anything for a 2017 Any Ideas
just bought a 2017 Tri Glide .. I need to move the driver floor boards out and if possible .. Everyone says they don't have anything for a 2017 Any Ideas
best thing i've done to my trike was to add DK's footboard spacers.
hardheaded
Put my floorboard extensions on last night (DK customs) on 2014 triglide. Much better position for my feet for sure. Also purchased the comfort lift kit but have not attached yet. The extension kit is a good bargain.
Here's the LINK the the floorboard extensions that will fit your Trike.
Here's a LINK where you can read about the benefits of the Tank Lift. (better cooling for the engine, and less buffeting for the rider, plus more)
Here's a LINK where you can read about the benefits of the Convertible Comfort Lift for your 2017 Trike.
Thanks for looking at our products.
Kevin
I took the 1" floor board extensions off my 2015 before trading it in and put them on our 2017 Tri Glide. It took longer to make the iced tea I drank than it did to install the extension kit....Lol.
The floor board ext kit is a must have in my opinion plus an extended rear heal shifter arm for all out comfort and floor board use. Also an extended front shift peg with the 1" floor board extension kit is also very nice.
See pic's
Ride Safe,
Bill G
Through Jesus Christ, I a sinner am saved. Not by my doing but through his doing by his sacrifice and Blood Shed on the Cross. His gift to all mankind that will only believe and accept him by Faith. Through his Death and Resurrection I am Saved by Grace and someday I will be with our Lord in Heaven forever.
I got my longer pegs at http://www.ebay.com/itm/EXTENDED-CAT...912837?vxp=mtr
v-twin cats paw shifter peg.
Pingle also makes a spacer that uses the factory shifter peg. I have the floorboard spacers and comfort lift kit from DK Products. They make a world of difference in the way my '16 handles. Also make note of the fact that most of us run the rear tires at 24psi. Keep the front up around 40psi. If you don't have the "No Loss" hand pump for the air shocks, get one asap. You will have to tinker with your air pressures to find the best setting for you when riding solo, with or without the trike loaded. Then, if you ride 2 up, repeat the process. I have an index card taped to the inside of the tour pack lid with both the air shock settings and rear tire pressures that work best for me.
Many of us on the board swear by this product. http://www.ride-on.com/ It acts as a sealant and it does a great job of balancing the tires. Imho, much better than beads. I'm sure others that are using it will chime in. I have it in my OE CTS-V tires too. If you order it, keep in mind that your rear tires are actually car tires so order the correct sealant for them.
2021 Mustang GT Premium A10 Handling Pkg
Red White and BBQ Texas, it's whole whole nother country .........
[SIGPIC][/SIGPIC]
2021 Mustang GT Premium A10 Handling Pkg
Red White and BBQ Texas, it's whole whole nother country .........
[SIGPIC][/SIGPIC]
Through Jesus Christ, I a sinner am saved. Not by my doing but through his doing by his sacrifice and Blood Shed on the Cross. His gift to all mankind that will only believe and accept him by Faith. Through his Death and Resurrection I am Saved by Grace and someday I will be with our Lord in Heaven forever.
If 1" out is not enough for you .... Private message me.
Bob