My 2010 Tri Glide reverse motor went out. It was brought to an electric motor repair shop and repaired. Once I put it back in the bike, it kicks the gear out but doesn't have enough power to move the bike.
Is that common? Did I wire it incorrectly? I have the larger red wire going to the 3/4 nut. The smaller one going to the tiny bolt on there. The two other wires are going to the bottom bolt as the ground. Can't find a wiring diagram online and I don't have the manual. I'm 99% sure, but I always end up second guessing myself.
Any help or a picture of the wiring would help. Thanks