Hey All; I know this has been posted in the past but looking for info, don't remember previous thread name.
My old U joint up front gave up the ghost. According to MT the front joint is not serviceable and to contact the dealer who built it for a new setup.
Have done all that, brought the new shaft home and spline will not fit on to output shaft. Went and swapped out front spline with another thinking it was milled wrong. 2nd spline will not fit either, has anyone had issues with getting MT new driveshaft onto the output shaft? I cannot find any burs on output shaft.
2005 Goldwing w/ motor trike adventure conversion (2010)
Old driveshaft grey joints. New driveshaft Green joints