my trike shakes when taking off in first gear. changed tranny, clutch, cvc, just put solid mount on tranny, any ideas as to cause
my trike shakes when taking off in first gear. changed tranny, clutch, cvc, just put solid mount on tranny, any ideas as to cause
Did you install new throwout bearing and pressure plate?
Stallion #406 // 2013 Tri-Glide
yes new throwout & pressure plate
also did wheel bearings doesn't do it in any other gear
Are you sure it is not a front end or suspension issue?
thinking possible suspension issue changing bushings for torsion and swingarm next, trying to post pic haven't figured it out yet
Is the shaking more of a hesitation-or does the fromt end wobble when you take off? Also, curious as to if it has a rake, and when the front tire was last replaced and/or balanced?
it is raked and definitely a shake sometimes it kicks out of gear trike is white 1 in my album trying to upload pic on forum but don't know how
Double check the tightness of all your connections, re torque them, had a similar problem with a clutch job on a car and it was a mount that did not get tight.
geannie was in trucking for 28 years have had this problems on big trucks when put under pressure,most of the time it would be flywheel needed to be resurfaced or replaced.Sounds serious, and already mentioned make sure its tight
How loose is the nut holding the springer front end. I would elevate the front a few inches, and torque it to where it has only a small amount of fall away (when you crank the front end left or right, all the way-and release it it barely moves to the middle or less!) If you look at my posts, you will come across one called "Brain Damage", it is a trike I built with a 40 inch over stock springer. Before I torqued the nut down it would shake and wobble. Just an idea.
At slow speeds I don't think it is the front end. It seems more like a clutch problem to me
You say it pops out of 1st gear when moving, either your shifter is out of adjustment or the syngonizer in the trannie for 1st gear is hot and needs replacing.
1st gear only pops out when shakes bad sometimes shakes worse than others
Does it shake when your letting the clutch out or after it’s all the way engaged?
Shakes when letting clutch out if u let it out slow shake isn't as bad
Thanks for all the help and replies