Does anybody know where i could find the thread that has the info on putting flex strip led's on the stallion mirrors, or has any of our stallion owners put them on?
Does anybody know where i could find the thread that has the info on putting flex strip led's on the stallion mirrors, or has any of our stallion owners put them on?
JD's lighting does a great job installing them on the Stallion.
Where is he located? If he is not in Ct. area i'll have to do it myself. thanks
dancerjim
white stallion #765
Ct.
I would guess that you can find a hot and a ground in the mirror area.
I just installed LED's to my front turn signals. I tapped into the wire loom just inside each turn signal wiring. Mine was easily attained by going under the hood area.
I did have to cut into each wire for the turn signals to get the 18gage wire to make contact. Those wires are extremely fragile. Works great and now I will know when my turn signals are on. pepper
Hey Bobby, you have a pic
William
Sorry...no. I just installed separate LED's to each side of the hood area near the windshield. Mine are approx 3 inches long and are red in color. Works great.
Inside the black plastic loom are 2 wires, on the left the purple/white is the hot and black is ground. On the right the gray/yellow is hot and black is ground.
Just rewrap the loom and stuff the wires back inside.
Remember to loosen the 2 phillips head screws on the sides so to make it easier to slide your LED wires into place. Then re-tighten when done.
Hope this helps