Reworking a set of Wind Dams
I got a set of older Wind Dams with the intent or rebuilding them. I liked the looks of the original smaller Wind Dams and the way the looked like the attached to the inside edges of the opening.
I reworked them and thought I would post some photos of how they turned out. I still need to put a finish coat of paint on them but I’m going to run them for a couple weeks to see how the work. Basically I cut them down to fit flush with the body and built a fiberglass edge on the front and top that match the inside body opening. Double stick 3M body tape is used to hold them in place. The key to a good fit is where you place the tape. The inside is finished with a rubberized paint to give a finished look.