Stainless steel swing arms
[ATTACH=CONFIG]47613[/ATTACH]
Printable View
Stainless steel swing arms
[ATTACH=CONFIG]47613[/ATTACH]
Intake manifolds.
[ATTACH=CONFIG]47701[/ATTACH]
[ATTACH=CONFIG]47702[/ATTACH]
[ATTACH=CONFIG]47703[/ATTACH]
[ATTACH=CONFIG]47704[/ATTACH]
Wedding up.
[ATTACH=CONFIG]47705[/ATTACH]
"Top Fuel Dragster" looking enough.
[ATTACH=CONFIG]47699[/ATTACH]
[ATTACH=CONFIG]47700[/ATTACH]
86mm forged counter weighted chevy journal stroker crank.
[ATTACH=CONFIG]47697[/ATTACH]
[COLOR="silver"][SIZE=1]- - - Updated - - -[/SIZE][/COLOR]
Chevy bottom vw top, h beam, 3/8" arp bolt, 5.5" long con rods for stroker pistons.
[ATTACH=CONFIG]47696[/ATTACH]
Seriously considering this cam.
[ATTACH=CONFIG]47692[/ATTACH]
ThumbUp Very nice job !!!
ThumbUp
Thanks!
I have been emailing with Pat Downs.
I am going to be hard pressed to get to my 200 hp goal because of my 4 straights exhaust. He told me without a merged 4 into one collector I will not be able to run the big cam.
Did recommend a more aggressive cam than what I have now.
I am going to study it again. Maybe now I can figure out a place to put a real header.
Good luck seems as though 4 into 1 riding that low with a mid engine is gonna be hard but I think if anybody can do it you will .
Now there is still the Ecotec 2.4 turbo 200 plus . :D LOL :Agree:
Lookin' real sweet! Great job on those manifolds, I wish I had your shop!
I went ahead and ordered 94mm pistons and cylinders. Also an Engle Fk10 cam.
New displacement. ........2387cc
Now to get back to working on it.