Do you need to lube the Drive Shaft on the older, solid axel models?
If so, how? I do not see any zerk fittings.
Thanks for your reply.
Printable View
Do you need to lube the Drive Shaft on the older, solid axel models?
If so, how? I do not see any zerk fittings.
Thanks for your reply.
I find it hard to believe no one replied. :xzqxz:
Sorry I’m not able to answer your question. Good luck with your research :wave4:
[QUOTE=Gideon;586240]Do you need to lube the Drive Shaft on the older, solid axel models?
If so, how? I do not see any zerk fittings.
Thanks for your reply.[/QUOTE]
if no fitting ..tough to grease it
[QUOTE=stacebg;588963]if no fitting ..tough to grease it[/QUOTE]
That is why I asked how is it accomplished?
Must be factory sealed. :wave4:
[QUOTE=trikeman;588983]Must be factory sealed. :wave4:[/QUOTE]
I will leave it alone. Thank you for your response.
Ride safe
God bless,
Gideon
[ATTACH=CONFIG]58960[/ATTACH]
I would contact the conversion manufacturer ... I'll bet there is a need to lube it. I had a heck os a time locating the zircon on my 08 Gold Wing with the Champion kit.