7 Attachment(s)
Another Bite of The Elephant
Removed the Tour-Pak, then Installed and wired the DK Tour-Pak LED Light Mount Bracket.[ATTACH=CONFIG]72022[/ATTACH]
[ATTACH=CONFIG]72023[/ATTACH]
[ATTACH=CONFIG]72024[/ATTACH]
[ATTACH=CONFIG]72025[/ATTACH]
Put a Paracord Tether on as backup for the Tour-Pak Lid Tether.[ATTACH=CONFIG]72026[/ATTACH]
[ATTACH=CONFIG]72027[/ATTACH]
Got the Extended Shift Lever on as Heel Shifter.[ATTACH=CONFIG]72028[/ATTACH]
Replaced Freedom Shields 7" Wide Touring with new 8" Wide Touring Medium Tint Windshield.
2 Attachment(s)
2016 Trike Supplement on Rear Lighting Wiring
Alan, I scanned the pages below from Appendix A on Wiring from my 2016 Trike Supplement Manual. Page A.3 showed me the Pin Layout, the Run/Brake/Turn Circuit and Wiring Color Codes for the Rear Lighting Connectors (Male & Female Ends). The last Page A-2 identified the Wiring Color Codes. This gave me all the info needed to connect the Posi-Tap Connectors on DK's Harness to the correct Run/Brake/Turn wires on my Rear Lighting Connector in Table A-4, Figure A-16.
If you have a Trike Supplement for your model year, it may have the same info.[ATTACH=CONFIG]72165[/ATTACH]
[ATTACH=CONFIG]72166[/ATTACH]
[B][COLOR=#b22222]Cautionary Note![/COLOR][/B]
[B][COLOR=#b22222]If anyone is not sure of their wiring's layout, then conduct a check using a DC capable Multimeter or at a minimum use a Test Light/Voltage Tester. It maybe overkill, but I always pull the 50 AMP Fuse (using the correct procedure for deactivation of a Security System with Siren Alarm) before I begin any Wiring Project, disconnecting the battery or even disconnecting Electrical Connectors.[/COLOR][/B]