started my next trike on sat 1/4 off to a running start... but building a 4 cyl hd trike at the same time so gotta work on that on a bit 3 attemps to upload pics .... fail
Printable View
started my next trike on sat 1/4 off to a running start... but building a 4 cyl hd trike at the same time so gotta work on that on a bit 3 attemps to upload pics .... fail
Wish you were closer, I could use something to do this winter.
couple more pics
Good looking welding and machine work.
enjoy the build
[QUOTE=jtilmon;210762]Good looking welding and machine work.
enjoy the build[/QUOTE]
thanks.. actually only machining so far was the hole in the pulley and the drilled holes in the flanges... flanges were flame cut with the torch and the sheet gussets are all plasma cut
roadie is on hold for a few days gotta move on the hd 4 cyl a bit
Very nice fab work. What was the donor vehicle for the trailing arm rear-end?
Very nice work.
thanx for the compliments... the arms with 2 struts are from a subaru and the 3 straust are from a mazda rx7
a little progress on the hd
motor mnt ready for machining
ThumbUp,,,,,Nice work ,really curious about those two engines running together . :Coffee:
me too no clue if they will get alone without killing each other !!! gonna find out
Check this website if you think getting two engines to run together might be a problem. <a href="http://www.docshd.com/Docs_Creations/Timeline/creationstimeline.htm" target="_blank">http://www.docshd.com/Docs_Creations...nstimeline.htm</a><br />
Doc also built a 4 engine 45 flathead five passenger that is on the same site.
saw that a few yrs ago<br />
identical motor is one thing but different ones???