Printable View
I need Your help. I have a 2008 wing with a Champion Kit on it and the kit is a solid axle and back end. I have greased the back joint with no trouble but I can't see how to get to the front grease fittings. I will be looking for Your help.
Thanks
Phil
In Lavonia, Ga.
I know were not talking the same kit but on the Champion on my old 1500 there was one spot I could get the tip to line up.Seems like it was done by pulling the right side cover off.You might have to use a grease gun needle to get it done.
If you are talking about the driveshaft U-Joints, the front one is factory sealed because there is no room for a great fitting.
I have a 12 and last year I pulled the driveshaft abd replaced both joints just to make surt they were in good condition. The U-Joints were standard size, and stocked at napa.