Re: Jacking up the rear end
I use floor jack at the tie-down points. I suggest removing the tires to facilitate ease of access to exhaust. Once the tires are off, put jack stands under hubs and remove floor jack. I have a stock 2010 Harley Tri glide with the Lehman conversion. I am not sure if it's the same as yours. Good luck........Mark
1 Attachment(s)
Re: Jacking up the rear end
Hi this is Jaime from Lehman Trikes. I happened across this thread today and thought I would run back and ask our conversion guys. They said if you don't have a hitch kit, then place a 2x4 between the hitch mounts on the rear frame (I took a picture of it - below) and then jack it up. Hope this helps!
[ATTACH=CONFIG]18869[/ATTACH]
Re: Jacking up the rear end
Heres a new attachment at Harbor freight for a floor jack. You can adjust the width because the sides slide in or out individually. And you can adjust the individual pad height from the one I saw in the store last week. Might be good for a solid axle trike.
[IMG]http://www.harborfreight.com/media/catalog/product/cache/1/image/9df78eab33525d08d6e5fb8d27136e95/i/m/image_22549.jpg[/IMG]