5 Attachment(s)
My DIY Engine Oil Vapor Venting System
[QUOTE=hddocfl;452568]In my own findings I have felt no suction on the vent hoses or the breather bolts that I can feel anyway. I did take a glass of water and stuck my vent hose in it with the stock A/C mod that we are talking about here and only get a small amount of air bubbles in the water, The water does not go down in the glass as to indicate a suction that is measurable that can be see. I would recommend to anyone not sure of this to not do it. I feel it is the right way to go and may later add a catch can but have seen no reason to add one now. Thanks Doc
BTW This mod can be undone in minutes back to stock , only showing a hole in the bottom of the plastic A/C housing.[/QUOTE]
I just finished my engine oil venting system.
[ATTACH=CONFIG]72169[/ATTACH][ATTACH=CONFIG]72170[/ATTACH][ATTACH=CONFIG]72171[/ATTACH][ATTACH=CONFIG]72172[/ATTACH][ATTACH=CONFIG]72173[/ATTACH]
3 Attachment(s)
Just a little different MOD
[QUOTE=hddocfl;449287]OK I did your mod,[/QUOTE]
Like your mod. My air box is different so my mod is just a little different. Only needed two hose connectors and hose. I did made a change to the routing of the hoses by filing to new places for the OEM hoses to be routed down the sides of the air box (rather then across the top) using the hose connectors and hose to the OEM tee at the bottom air box where I drilled a hole to exit hose.
[ATTACH=CONFIG]72154[/ATTACH][ATTACH=CONFIG]72155[/ATTACH][ATTACH=CONFIG]72156[/ATTACH]
Will install a small catch can when I get it. Will I have to re-route the hose that laies on the engine housing because of heat melting it?