Leading Link procured. Want to "float" the brakes. Need help.

I want to go with this one? [LEFT][COLOR=#333333][FONT="Helvetica neue"][B] Springer Front Caliper Bracket Mount ( Left or Right )[/B][ATTACH=CONFIG]78886[/ATTACH] Can a grease fitting be added? IF there is enough material and what is the measurements side ways to clear my swing arm to rotor, I hate all these variables' :gah: [/FONT][/COLOR][/LEFT]

Jumping into things is not always the best, but it can all work out in the end. I forgot the process to doing metal work, so I did get things to the machine shop to get my holes cut out, we talked more and I realized I was skipping a few steps. I will get on this more so that it gets done. Zech is more excited to help finish this up than I thought, it felt good.

:D

Oh, spent over a week hand sanding and getting dia. of a bushing large enough to slide over the wheel bearing spacer, oh and I get to do it again after the press fit of them, all gets a bit tighter after pressing them in.