Printable View
So I have a Lehman/Champion IRS trike conversion kit on my 2011 Ultra limited that I purchased not long ago I took the seat off and noticed several of the bolts which look to be the sub frame attached it to the harley frame are loose do you have a torque spec for these its either 4 or 6 bolts can't remember exactly thanks
Can you post some pics of the bolts?
[QUOTE=PGLGHDBLDR;821570]So I have a Lehman/Champion IRS trike conversion kit on my 2011 Ultra limited that I purchased not long ago I took the seat off and noticed several of the bolts which look to be the sub frame attached it to the harley frame are loose do you have a torque spec for these its either 4 or 6 bolts can't remember exactly thanks[/QUOTE]
general rule of thumb "tighten the 1st one till it breaks, tighten the rest a little less" works best on blind holes
but seriously this is a great reference
[url]https://www.boltdepot.com/fastener-information/bolts/US-Recommended-Torque.aspx[/url]
[QUOTE=PGLGHDBLDR;821570]So I have a Lehman/Champion IRS trike conversion kit on my 2011 Ultra limited that I purchased not long ago I took the seat off and noticed several of the bolts which look to be the sub frame attached it to the harley frame are loose do you have a torque spec for these its either 4 or 6 bolts can't remember exactly thanks[/QUOTE]
Rick, your description is vague. You need picture uploading skills too. [B]Did you ever figure out the brake pads yet ? [/B]
Seat Mount
1. Install the seat mounting bracket to
the upper trike frame using the following hardware.
Torque hardware to [B]30 ft-lbs.[/B]
• (1) Seat Mount Bracket– S002118
• (8) 3/8” x 1-1/4” Hex Head Bolts– CB2018
• (16) 3/8” Flat Washers– CW2180
• (8) 3/8” Lock Nuts– CN3051
[QUOTE=stacebg;821594]general rule of thumb "tighten the 1st one till it breaks, tighten the rest a little less" works best on blind holes
[/QUOTE]
Or tighten till they strip and then back off a 1/4 turn.....:D...