Started on the pulley hub this evening.
[ATTACH=CONFIG]47777[/ATTACH]
It is two pieces roughed in and welding together
Next is final machining to size.
[ATTACH=CONFIG]47776[/ATTACH]
Printable View
Started on the pulley hub this evening.
[ATTACH=CONFIG]47777[/ATTACH]
It is two pieces roughed in and welding together
Next is final machining to size.
[ATTACH=CONFIG]47776[/ATTACH]
ThumbUp Some damn good reading guys ,,,amazing what you can learn from listening to a couple of guys talking shop , keep it up for those of us learning . ThumbUp
Whittled on that hub an hour or so this evening.*
Still not done.
Why is it I hafta make all my own parts?
Looks like this.
[ATTACH=CONFIG]47778[/ATTACH]
[ATTACH=CONFIG]47779[/ATTACH]
You gotta admit ... there is some skill there
Well Done
Ya do what ya gotta do to make all the parts you want to fit together.
Still have a good bit more to go, especially on the front end.
Whittling on pulley for it.
[ATTACH=CONFIG]47780[/ATTACH]
Stinger608
You get my pm?
Have most of that pulley made.
Mocking up the bottom end again.
It has been lightly assembled so many times now.
I am gonna check the cam lobe center degrees. I am hearing that the engle cams are bad about not being to spec. I always ran the eagle cams "straight up" as in exactly like the cam card. But they are spec at 107 degree which is fairly advanced. The engle is up posed to be 108 degree and is what I want now. But i hear that their qc is poor now and it could be anywhere up to 5 degrees from spec. So i gotta find out.
Pulley.
[ATTACH=CONFIG]47783[/ATTACH]
[ATTACH=CONFIG]47784[/ATTACH]
Enough of the bottom end put together to degree the cam.
Then wasted an hour looking for my degree wheel. Never did find it.
[ATTACH=CONFIG]47781[/ATTACH]
God all mighty brother!!! That is going to be one serious VDub motor man. :pepper:
That pulley turned out amazing bro!!! ThumbUp