3 Attachment(s)
what I finished up today.
Good afternoon, so I spent the morning finishing out the tapping of this bushing, cleaned everything up super clean, than put it all together and installed it. Now to fill the cooler with oil first, than connect the coolers input hose and fill the engine with fresh oil.
New factory oil pressure springs where installed yesterday, and now the oil temp. sensor is inline on the return flow of oil from the cooler before it goes back into the engine.
Bearings came in the mail today, so I hope to get that done this rainy weekend, and maybe the Trike back together.
[ATTACH=CONFIG]56262[/ATTACH]
right side view.
[ATTACH=CONFIG]56263[/ATTACH]
left side and a view of the inline sensor.
[ATTACH=CONFIG]56264[/ATTACH]
I used the wheelie bar mounting bolts to also secure the uprights on each side for
the cooler. I ran a cross brace to each upright and attached the cooler to the cross
brace, of course after I made mounting brackets for the cooler so I could do that.
A bit worn out, but thinking of the bearings and how I will set the new ones, I was thinking of using a bearing drive punch, can borrow the set from the local parts store.
Or do I just freeze the new grease packed bearings, so they contract, and than set them ?
Never done a VW before, do they tape back in easy, or is time to get them pressed in ?