MT Phoenix build

[87Trike1200]

Last fall when my 1500 was "converted", my installer (at my request) took a series of 20 pictures during installation. Here's 2 that I thought were interesting. Also included, the "finish product"...

Motor Trike Phoenix IRS rear..,



Rear in place





Hard to see, but notice the TOI flag in the rear corner.

[DTR 11TG]

I like the looks of the lift table they are using, do you happen to know what brand it is?

[87Trike1200]

I expect to be there tomorrow and will try to remember to ask.

[DTR 11TG]

Thanks, it would be great if you can find out.

Also, this should have been in my first post, that is one sharp looking IRS system!

[Tip Schwartzbeck]

Very nice trike!!
Tip

[87Trike1200]

I like the looks of the lift table they are using, do you happen to know what brand it is?

Tom, as mentioned, I was at "my" trike installer's today and inquired about his lift's. Actually, there are two. The one in the picture above is a "Ranger" which he likes except it's best only with "regular" width trikes such as Motor Trike. It is not good with "wide" trikes such as Hannigan or similar.

His other trike lift is an "Eagle" which is usable with "all" width trikes. Except for the width issue, he likes both.

That's my total knowledge of the lifts - hope it is helpful.

[DTR 11TG]

Tom, as mentioned, I was at "my" trike installer's today and inquired about his lift's. Actually, there are two. The one in the picture above is a "Ranger" which he likes except it's best only with "regular" width trikes such as Motor Trike. It is not good with "wide" trikes such as Hannigan or similar.

His other trike lift is an "Eagle" which is usable with "all" width trikes. Except for the width issue, he likes both.

That's my total knowledge of the lifts - hope it is helpful.

Very helpful, thanks Warren.