My LCD lights up ok but cannot reset trip, view temp, or mode button does not work. Anyone have any ideas
Thanks
John
My LCD lights up ok but cannot reset trip, view temp, or mode button does not work. Anyone have any ideas
Thanks
John
Not sure what you are talking about, but when in doubt, power down. Just disconnect power for a minute and then try powering up again. Maybe that will do the trick.
[SIGPIC][/SIGPIC]
2008 GL1800 Level 3 W\2009 Motor Trike Adventure IRS Kit
1999 Valkyrie Interstate W\2001 Lehman Predator Trike Kit
2021 Can-Am Spider F3 Limited (Girlfriends)
2009 Vulcan 900 Classic, full dresser (Girlfriends)
2019 Coachmen Catalina Trail Blazer 30' Toy Hauler/Camper
Morning John, Did you see we finally got a little rain up here????
I can't believe all those switches went bad at once and there is only one common point to each of them. When removing the dash shroud there is a connector positioned just below the buttons you speak of. It's possible this connector has come loose. I also noticed in the service manual that a common ground for all the switches comes through that connector from the combination meter assembly itself. I would start my search in those areas.
Hope that helps....
Jerry "Gold Rush" (aka: "SPOOK") San Angelo, TX
2015 GL1800/Roadsmith HTS1800
TOI - IBA #23804 (SS1K & BB1.5K)
I'm like an old race horse..... I can still run the race -- Just ache more at the finish line and need more rest between outings.
Found a loose cable and everything works. Had a little trouble getting it reconnected, thought I was going to have to pull the inst cover off. Thanks everyone for the help.
John