Starter motor "again"

[rog1215]

Starter motor engaged and fried leaving me wondering if anybody has figured this problem out yet. I have had it "fixed" under warranty twice and now i am outside my warranty.
Was going to install the remote switch on the end of the solinoid but realized it would be difficult to not burn my hand trying to hit that button to start motor. Anyway its on my lift now and i will tear into it tomorrow.
all sugestions are welcome.

 

[Bikerbozo]

My motor and switch were replaced over 30,000 miles ago on my '10 TG. Haven't had any problems since. If they didn't replace the switch also, that may be issue. Ignition switch has also been replaced. Note there is an updated motor that has higher torque. I actually have to give the throttle a little gas to keep from stalling when using it. Same P/N as original.