Hello Everyone,
Just installed new 2" pullback handlebars on my 2011 TriGlide and I was wondering if anyone has any insight on the sensor that is located inside the clutch lever housing.
Since installing the bars I have to pull the clutch lever in very, very hard to get that sensor engaged so I can start the trike. I have played with the tightening of that housing, but it still seems that the sensor is just too short to make contact with the clutch lever. Anyone else have this problem and if so what did you do to correct it?
I know, I could put the trike in neutral and start it that way, but that is a pain.
Any suggestions would be awesome!
Enjoy and Ride Safe!