I saw on Facebook that J&S jacks now has a trike jack available. Here is the link to the website with a demonstration video >> Products Page | J&S Jacks
I saw on Facebook that J&S jacks now has a trike jack available. Here is the link to the website with a demonstration video >> Products Page | J&S Jacks
Overcoming Adversity is the path to better ideas!!
2008 Roadglide w/ MOTOR TRIKE Kit
S&S 124" Headwork & Custom designed cams by John
Custom made right side shifter (Lost my left leg above the knee due to a hit n run driver) SOOS's custom made floorboard spacer
the center of gravity on the tri-glide is just fwd of the rear axle.
so you can't use any jack from the side to jack the whole tri-glise off-of the ground. i use a 4 wheeler jack to lift the front tire off the ground,(about 100.00 at northorn tool) then use a 32 ton auto jack under the rear to lift the rear tires off of the ground.
just my experience.
Not real clear if this trike jack will work with a trike with running boards, etc.
wiredgeorge Mico, TX.
I have one I bought from Canadian tire (in Canada eh?), when I was running on two wheels... use it all the time. Just butte it up against the frame as far back as you can go...on a VTX anyway. But you're really going to want to put something under the axles to stabilize it once it's in the air, too.
I'd be very interested, but I would also have to be assured that it would work for a GL1800 Roadsmith with the wing boards and a belly pan!
I have a pitbull jack adapter that works just the same and not as fancy as the above mentioned unit..
Pitbull Motorcycle Lifts - Video
http://i1347.photobucket.com/albums/...pswnuweejq.jpg
Red Ultra Powered By Head-Quarters 120, Easy Clutch Pull By ClutchWIZ. 2012 GL1800 Hannigan. I've yet to ride a stock Harley which wasn't in need of a mechanical intervention.
i bought 2 screw jacks from an auto salvage for $10 bucks,welded a couple pieces of angle iron on top & bottom for stability & glued rubber on the top pieces so it wouldn't scratch the frame.Been using these for over 10yrs.Small enough so you can roll around & not be in the way of working on most anything.