Turn signals wiring on my CSC running boards (2005 GL1800) were apparently cut off about 6 inches from the each lamp. I would appreciate any information about how to reconnect and get them working again.
Turn signals wiring on my CSC running boards (2005 GL1800) were apparently cut off about 6 inches from the each lamp. I would appreciate any information about how to reconnect and get them working again.
Not sure if this is what you are looking for, but in the back of the installation guide there is a wiring diagram that might help.
http://www.californiasidecar.com/dow...structions.pdf
If not that, then maybe the instructions for the Ground Effects;
http://www.californiasidecar.com/dow...ra_GRD_EFX.pdf
Thanks for the suggestions and material. Will pursue.