Roadsmith Hitch Draw Bar Length

[lgjhn]

Hi,
I just recently converted to a Roadsmith trike.
I had the nerf bar rear bumper added (see pic below).
I did not buy the optional Roadsmith draw bar as I wanted an aftermarket one.
My question is: what length draw bar to get. Obviously, it's got to be out past the rear and bumper. Anyone have this combination? IF so, how far is the ball hole from the pin hole on your draw bar? Or how far past the rear is the ball located?
Tnx.
LJ

[saab9k]

I would send Roadsmith a email, they will tell what length they sell.

[Bullet]

Just took a pic. I bought my hitch at wally world. Should work.

[bikerbillone]

The ball or the entire hitch. I need to get mine set up for the RS receiver. By the way, sure like that black accent. How did that happen?

[vo2max]

2102 OEM RS draw bar.

7" center of the pinhole to the center of the ball.
Overall length of the bar, tip to tip, is 12.5"

Hope that helps.

[lgjhn]

2102 OEM RS draw bar.

7" center of the pinhole to the center of the ball.
Overall length of the bar, tip to tip, is 12.5"

Hope that helps.

That's exactly what I was looking for.
Thanks all.

[Bullet]

The ball or the entire hitch. I need to get mine set up for the RS receiver. By the way, sure like that black accent. How did that happen?

I need to get mine set up for the RS receiver.

RS already did that for you, all you need to do is buy a hitch from RS or walmart and do the wiring for trailer lights (cheapest way) or you can go buy a wiring kit from a motorcycle shop on the internet and spend 70 or 80 dollars for one of there plug and play adapter kits . Easiest way to do the wiring is to buy a five into four wiring system at walmart or other.

By the way, sure like that black accent. How did that happen?

I was just walking along with a can of paint and tripped. Some thoughts, some head scratching, some tape and a little paint.