What did you do to Your Tri-Glide Today?

[rhino 2]

No sence of humor

Also your helmet had to have reflected tape that can seen from the sides and back..

Even though adding tape or paint to a helmet will void the helmets warrantee..

The state inspection went like this.....You pull up to the staton , Park the bike go inside the office ' Brake up the inspectors grab-ass party, Then loudly tells you to wait out side....

10 15 minutes...Grumpy comes out , Says license registration insurance .....Reads them in slow-motion , Then says start the engine ...Then turn on the brights , left signal , right signal step on the brakes.....Blow the horn, Eye balls the helmet, Turns around walks into the office , 10 minutes later comes back with the passed sticker...

[RAHRAHJR]

Rec'd the new larger filler pad today. Needed longer screws like a few have suggested. It seams like it is a little too big and stiff, and I hope the warmer weather(if it ever shows up) helps loosen up the material.

I also added the adjustable passenger footboard mounts to help the wife get comfortable. Now with the tour-pak pushed back 2" it looked like her legs would be un-comfortable on long rides.

[Sully]

Had the 5k oil change,3 holes full synthetic and filter, Plus they checked every thing on the 5k check list ...And also replaced a seat bolt with a Gen'u'wine HD One And for good reason, The one i used was a 3/8 head, And if i had to remove the seat on the road i would need to carry a 3/8 socket i didn't think about that till they tried to remove the seat.....Also they reprogramed ? the lights so the spots will stay on with the high beams ...Why do i need that , Who knows But just did it N/C....

Bob, what did the dealer charge for the 5 K Service ? They are running a special here for $299.

[rhino 2]

Bob, what did the dealer charge for the 5 K Service ? They are running a special here for $299.

With tax....Total out the door 116.51......When you buy a bike from them the 1k And 5k there isn't any labor charge.....[90$ an hour]

[graygoat]

Couple days ago I had to move the trike to get the snowblower out for 4-5 inches of snow! Now that really sucked!

[1dn5up]

All my sno equipment is done ✅ Anything that accumulates now , the good lord will remove.

Just one of those days just couldnt get warm. Got the house to 75* with long John top. Not sick just can’t get rid of this chill.

[DK Custom Products]

When they has bike inspections in Jersey, That was one of the reasons why they would fall you.....High Beams on , fog/spots lights must go off...

Thankfully, Federal Law, quite a few years ago, made it illegal for States to require the fog/spots to be off when high beam is on.

Kevin

[Rmitchell55]

Removed the cover that has been on for over a week. Having some work done on my house and it's been in the garage covered. New roof and new stucco on the front. Haven't been able to get it out of the garage due to construction trailers taking up all of my driveway. Hopefully I can wiggle it around tomorrow and get out, only one trailer in the driveway now and I have a 250 mile ride planned.

[TonkaDriver]

I was at the Basic Three Wheel Rider Course - Day 2. which means the day for the skills test. I was on course waiting for another student to clear the course and while searching for neutral my shifter shaft stripped out. lucky for me a Harley dealer was a block away. I left the session and rode to the dealer in 1st gear. $110 and an hour later after kneeling down on hot Arizona pavement I completed my first parking lot repair.

The result is I have to reschedule the day 2 riding portion and travel 110 miles one way for a 4 hour riding session to complete the course. The ride down will be in the very early morning but the ride home will be in the blazing AZ heat. I also learned that I need to put together a better tool kit than the one provided with the trike. If you aren't learning, you aren't living.

[jc1300]

Couple days ago I had to move the trike to get the snowblower out for 4-5 inches of snow! Now that really sucked!

GrayGoat......that is the saddest thing I've heard in a long time......That would really piss me off too! jc

[Fearless]

I was at the Basic Three Wheel Rider Course - Day 2. which means the day for the skills test. I was on course waiting for another student to clear the course and while searching for neutral my shifter shaft stripped out. lucky for me a Harley dealer was a block away. I left the session and rode to the dealer in 1st gear. $110 and an hour later after kneeling down on hot Arizona pavement I completed my first parking lot repair.

The result is I have to reschedule the day 2 riding portion and travel 110 miles one way for a 4 hour riding session to complete the course. The ride down will be in the very early morning but the ride home will be in the blazing AZ heat. I also learned that I need to put together a better tool kit than the one provided with the trike. If you aren't learning, you aren't living.

I noticed the shifter was loose on old shiney tried to tighten it no deal. Replaced with Pingel Greasable shifter shaft a little pricey but I don't plan on having that problem again. Travel safe Fred

[graygoat]

50 degrees today, so got out for a short ride (no time for longer)! Weather turning to crap again from tomorrow through Monday. This chit is getting tiresome!

[1dn5up]

Took it off the table lift , installed my true dual beam headlight. Aimed it then Faced it towards the street for a fast getaway back home.

[Zammy]

I did a privacy reset on the boom box this afternoon, I had some waypoints on the GPS that I couldn't delete. Also ordered a new Avon Trike tire to replace the original Dunlop, it's looking a little worn, got 15,000 miles out of it.

[TomWoodgeard]

Installed a new rear brake light switch from O'Reillys - $9.00 H-D

Version $19.00........

Flushed and bled rear brakes using Speed Bleeders. Correct size for my year (2011) is SB8125L

Lots of air bubbles...............

[TonkaDriver]

I did a privacy reset on the boom box this afternoon, I had some waypoints on the GPS that I couldn't delete. Also ordered a new Avon Trike tire to replace the original Dunlop, it's looking a little worn, got 15,000 miles out of it.

What does a privacy reset do and how did you do it?

[Zammy]

Kurt, the privacy reset just gets rid of any waypoints in the GPS that are stored, lets say you're selling the bike and don't want anyone knowing where you've been or if you had Home programmed. In my case a few routes I imported from a GPX file would not delete so I did the reset, it doesn't change the software version you're running or wipe out any favorites you might have programmed.

1. Turn IGN OFF. Wait 15 seconds.

2. Press and hold power/mute button. Turn IGN to ACC.

3. Continue to press power button for 2 seconds after the WARNING screen is displayed.

4. Release power/mute button and accept warning.

Then you will have to scroll down all the options to get to reset, under Reset there is the privacy reset option.

Keep in mind this is for the 6.5 Boom Box from 14 on up, I have a 15 but don't know about the setup on the 17 & 18 M8s

[Fearless]

Finally got to change oil ended up froze in with last seasons oil, more importantly tested out new greaseable shifter shaft it really made shifting effortless so smooth. The OEM was horrible and I didn't even know it, bad for sometime never dreamed of it being corroded and cruddy. on the inside. That Pingel shaft is really nice. Ride safe Fred

.

[RAHRAHJR]

Installed (2) of my birthday gifts today on the Trike. A paint matched outer fairing vent and a vent screen.

[TonkaDriver]

Installed (2) of my birthday gifts today on the Trike. A paint matched outer fairing vent and a vent screen.

Where did you get those, they really look good.