Harley Freewheeler Trike Owners Thread

[headheaded]

It's round bar that was formed in the profile of the floorboard and angled out a little, it's used to keep my prosthetic from sliding off. Yes the controls were modified; a linkage system and a left side brake pedal were added so that I can use my left foot to shift and brake. Both were fabricated and installed by Maxwell Brothers Cycle Shop near Petoskey, MI. They are a good group of guys at that shop that make sure that any mod's are done to meet your expectations and needs.Red

i need the same thing except i need to move the shifter to the right side or come up with a way to shift the bike. building a cage around the footboard is going to have to happen too. thanks!

[Red59]

building a cage around the footboard is going to have to happen too. thanks!

I think I shared these pic's before but I made this from a piece of 2" aluminum angle iron for my last trike. Couple hours time cutting and forming wasn't to bad to fabricate. Since Maxwell Brothers was doing the brake mod I just asked them to come up with something for this one.

[dirtdobber]

I don't do much to a new bike/trike. I wait until I have my first service done. Dyno tunes or a tune has to wait until I get between 4,000 to 5,000 miles. Doing it before it limbers up is a waste of time and money. You will need a retune if it is tuned to early.
getting rid of the cat will really help. I think it needs full stage one to get the mid to upper range.

Just a thought.

[HDB0B]

Roxy has 7700 miles on her and we really have no heat issues (all stock exhaust with cat). She sounds much better than new .... so some of that exhaust packing has loosened up! Like above I think you really need at least 5K miles before the engine can be considered broken-in. I remember when new you could hear the pistons going up and down ... it was tight.

I contemplated many of the suggestions for lessening the heat .... but decided to wait. For the style of riding we do .... Roxy is fine as is. Down the road, when the warranty is up, I may have the itch for some major engine upgrades and a tuner.



Bob

[BlackWidow]

Hi everybody. Traded my 2011 Road Glide for a Vivid Black Freewheeler. I live in SE PA, Vin # 856209

[clint44]

Hi everybody. Traded my 2011 Road Glide for a Vivid Black Freewheeler. I live in SE PA, Vin # 856209

Congrats on the new trike!

[LadyonaMission]

I contemplated many of the suggestions for lessening the heat .... but decided to wait. For the style of riding we do .... Roxy is fine as is.
Bob

I live in San Antonio, Texas so heat is just one of those things that I have to deal with. I have decided to add only the heat deflectors like the ones you already have.

[FLRT]

Hi everybody. Traded my 2011 Road Glide for a Vivid Black Freewheeler. I live in SE PA, Vin # 856209

Congrats!! They are the dog's balls!

[missedem]

Hi everybody. Traded my 2011 Road Glide for a Vivid Black Freewheeler. I live in SE PA, Vin # 856209

congratulations and welcome...

[Keystone]

Congrats on the new trike!

The Freewheeler's just keep on multiplying!

[Harlot1]

So glad to find this forum and so many other happy FW riders! Hey - any recommendations on rider (not passenger) backrests...... Thanks!

[screwball]

We live on the desert in Southern California, we have hot summers too. The heat you are feeling is radiated heat from your engine. Removing the cat will do very little. The problem I have found is proximity of your lets to the engine. I put floor board extensions on wife's Tri-Glide and my Freewheeler. That extra inch really make a difference for under $100.

[Bill G]

I agree with screwball living not to far from him and it gets hot here. The floorboard extentions are sweet. The extra inch helps a lot with the heat plus the added benefit of the room they give you.

Floorboard extentions are one of the first things I installed on the Freewheeler. A must have on a Trike in my humble opinion. The floorboard extention kit ran me $49.95 plus shipping.

Ride Safe,
Bill G

[dirtdobber]

Kuryakyn makes a set that will either move the FB forward or rearward a inch but it also moves it outward a inch.
Kuryakyn # 4588
If you are not using the lower fairings it's not as noticeable of a heat change when using a catless header. Being open, no lower fairing, the air movement lets the heat pass instead of being trapped. There is a big difference with a no cat header. I use a ward fan to assist in controlling the heat. I can tell the difference because the fan doesn't come on nearly as much. In fact it doesn't come on at all when riding like it does with a cat pipe. A tune is needed to aid in performance and that will lower the temps even more.
try to cool down a CVO 110. You can't very well without a catless header and a good tune.

[Harlot1]

I LOVE my Freewheeler - best H.D. I've ever owned...... QUESTION.... there is a 'slice' in the stock seat which IMPLIES the ability to install a rider backrest .... BUT I can't find one thru H.D. or J.P. .... HELP???

[Ridernut]

Joe
Texas
Amber Whiskey
854200

5000 miles of smiles so far.

[Sunman]

I LOVE my Freewheeler - best H.D. I've ever owned...... QUESTION.... there is a 'slice' in the stock seat which IMPLIES the ability to install a rider backrest .... BUT I can't find one thru H.D. or J.P. .... HELP???

The standard Harley Touring model backrest will fit on the Freewheeler and so will the Harley adjustable backrest for touring models even those it doesn't say they will in the Harley catalog.

Sunman

[bib/bob]

bob
Florida
Superior Blue

[dirt]

Dan
Spokane WA
Amber Whiskey

[bib/bob]

here is a H/D page for the F/W might help with getting your parts. and giving you some new ideas for new one's. http://www.harley-davidson.com/shop/...avedmodelCode=