front rotors

[Dragon]

Good evening
I have a question about how the float pins on the rotors are configured
should they be float pin with 2 spring washers then pushed through hole
and then washer and c-clip, or should they be float pin pushed through
hole and then 2 spring washers and washer and c-clip. I was driving
around a parking lot when I heard a pop from the front end.
went and did my shopping and came out and drove away hearing
another pop so I slowly drove home and checked out the front end
and found one of the float pins had broken and then just fell out
. what exactly is the right config for the float pins.
Thanx
Dragon

[trikervet]

The 2 spring clips go on the same side as the "C" clip. You should be able to look at one of the others and see the config.

Good evening

I have a question about how the float pins on the rotors are configured

should they be float pin with 2 spring washers then pushed through hole

and then washer and c-clip, or should they be float pin pushed through

hole and then 2 spring washers and washer and c-clip. I was driving

around a parking lot when I heard a pop from the front end.

went and did my shopping and came out and drove away hearing

another pop so I slowly drove home and checked out the front end

and found one of the float pins had broken and then just fell out

. what exactly is the right config for the float pins.

Thanx

Dragon

[Dragon]

all my pins have the float pin 2 spring washers and then
put through hole and flat washer with c-clip. I have also been
having problems with the rotors overheating maybe this is the problem.
Thanx
Dragon

[trikervet]

You might call Richard at TMS and ask him. A few years ago I had to swap over my rotors to new hubs. I put it back like it came from the factory and that was per my last post. I don't remember a flat washer in the mix, maybe their was. Hope you get it sorted out.

[Dragon]

I took your advise and changed my pins configuration yesterday
and will take a ride today to see how it changed. I will still give
Richard a call on Monday

Dragon

[Dragon]

Hello
I talked to Richard and the config is to put the float pins through,
and then on the inside of hub goes 2 spring washers and then a
flat washer followed by c-clip. this seams to have solved my overheating
of the front rotors but in the next 300 miles I broke another float pin.
has anyone had a problem with breaking float pins. when I got the
bike there was a bag of new float pins and accy. now I wonder if
that was a hint check float pins all time

Dragon

[Gorilla]

2008 with almost 80k and never have had one come out possibly something bent?

[ODDOMAN]

Any pics?