Hello.Has anyone come up with the number to plug into the power vision to calibrate the speedo?
Hello.Has anyone come up with the number to plug into the power vision to calibrate the speedo?
Thanks, but I have a different diameter wheel on the freewheeler, unless the signal comes from the transmission. Then that number would work.
it comes from the trans
Stallion #406 // 2013 Tri-Glide
if your saying will correcting the speedo also change the odometer the answer is yes. They both use the speedo sensor for calculation.
Stallion #406 // 2013 Tri-Glide
I am having CCRS (Chronic can't remember squat) moment here. How do you get to the screen to change the calibration?
Thanks
Dave
2015 Tri Glide - Hot Pearl White/Blue
82 FXR
I found it in the winpv software. There is a page on the pv. I just don't know where when I get home from work.
Thank you gentlemen. I had to run out for a bit, but I will work on it when I get back home.
Dave
2015 Tri Glide - Hot Pearl White/Blue
82 FXR
I did the math and came up with this number. 2463. My speedo is dead nuts on at 60mph.
This how i did it. I got this off of one of the Harley Forums.
1. speed shown on speedometer / speed on gps = number
2. number X pulses per km = new value
example
1. speedo reads 60
2. gps reads 64
3. 60 / 64 = 0.9375
number = 0.9375
4. current pulses per km = 2300
5. 2300 * 0.9375 = 2156
2156 is the new value to enter in the Speedo Calibration
You can change the speedo calibration with the PV device by going to Program Vehicle>Quick Tune>VSS
Note: using Quick Tune will only change speedo cal in the ECM, not in your map in the tune manager
<a href="http://www.fuelmotousa.com/">Visit Fuel Moto USA</a>
Tech Support: 920-423-3309
Email: info@fuelmotousa.com