Has anyone tried , or does anyone know if the tri bar led taillight will fit on freewheeler fenders . I realize it will probably have to take some reengineering to make it work . just checking to see if anyone has tried this.*
Has anyone tried , or does anyone know if the tri bar led taillight will fit on freewheeler fenders . I realize it will probably have to take some reengineering to make it work . just checking to see if anyone has tried this.*
Yes , would like to replace stock taillights with the tri bar led taillights . I have the led taillight on a custom build , like the look . haven't taken delivery of my freewheeler yet , so can't physically compare fenders . if close , *I'm sure they could be mounted . just not sure if they can be used for turn signal function along with normal taillight function . does anyone know if these lights can be wired for turn signal along with normal taillight function??
Can anyone measure inside width of freewheeler rear fender about 3" down from top . the fender i have the tri bar light mounted on is approximately 9" wide . tried to download a picture of the one I have and can't figure out how to load it .
Pretty sure the wires going to your Freewheeler tail lights are already Run-Brake-Turn, so it should be a matter of just wiring in the Tri-Bar to do the same.
If not, we have a RBT module that will convert a single OR dual function LED to R-B-T (triple function).
You can see it HERE.
Kevin