Floored again on furniture movers, front breaks static check, and the chains lock up, AGAIN, last time took the jack shaft apart and everything works fine, can rotate the wheel in reverse all day long BUT forward will make 1/2 to 3/4 turn then sudden lock up??? AND... the engine shift lever is hitting the exhaust 1/4" BUT on the bright side I'm getting closer. I know I'm thinking a little ahead of myself BUT will a short video be down loaded of it running around the block? Does anyone know???
JakeJacobsen@Pinterest.com
Looking good. On the chains locking up, are you turning the rear wheel forward by hand and pushing all the slack to the top ? Could it be causing it to bunch up in front of a sprocket? Turning with engine power would put the slack on the bottom and not cause a problem.
JakeJacobsen@Pinterest.com
Here is the video on FB:
https://www.facebook.com/n/?video%2F...en%40yahoo.com
Did not work for me? AND: Pinterest did not work?
JakeJacobsen@Pinterest.com
Tried the video too... looking forward to the test ride and evaluation. looking great!
Nuff Said," Were Burnin Daylight, Lets Ride"(Sober 37 years)
Current ride : 2021 FREEWHEELER M8, oldest ride 1960 FL
looking good
Stallion #406 // 2013 Tri-Glide
---Front wires are wired together and routed to the harness, but not connected yet, I will double check my ignition wires first and see if I can get it to turn over and start, OMG! I'll need extra strength toilet paper (Charmin extra strong, boy that will clog you crapper for sure, ) for this one because you gunna know I'll sheet my pants when it starts, video for sure...
JakeJacobsen@Pinterest.com
and so are we looking forward to the video.
Stallion #406 // 2013 Tri-Glide
Always super alert when putting power and fuel to a new creation....most times safety switches etc. not connected, so double check neutral on the tranny. Be ready to disconnect the battery and have a fire extinguisher handy....then time to light up! Good luck!
JakeJacobsen@Pinterest.com
Thank you Jack but I do not have, so I hooked 2 little jumper wires straight from the battery to the horn and made a little click, So I got 1 of my eScooter batts 12V and wired it the same way, heeheehee, scared the wife with sound. Ordered a new battery from eBay this morning,
JakeJacobsen@Pinterest.com