Has anyone out their tried this in your tires? getting ready to replace front tire on her and am going to try the Avon Cobra trike tire and thought as long as doing this might try the ride on in it as well. Have read good reviews on both so we will see how tire holds up on trike only 7,000 on front tire and its cupped bad.
Some swear by it, not I.
I used it in my 1200's tires, balances good. Rear valve stem leaked, Ride on stopped leak but by then tire was low I rekon. I went to move it off center stand, could tell rear tire was really soft. Got it back on CS, check tire, dang near flat and I could see white stuff at rim edge on tire, like seaping out. Checked front, it too had some white stuff.
Well, I could see I needed to pull rear and swap in a new stem, what a mess I find inside. Took a good while, water, soap, brush, and a wire brush to get wheel lip clean. Finally got rim and tire innards clean, put in new short all metal valve stem and 3 or 4 ounces of Airsoft plastic 22 cal. BBs this time, and aired up after reinstall on bike. Then I took front wheel & tire off, dismounted it to find a mess as well and it never was "low". Another hour or so cleaning rim and tire, scrubbing, new all metal stem, remount, put in 3 ounces of the same BBs, aired up, and pitched the unopened Ride On kit into the trash.
To each, his own … but not even in my lawnmower will I ever put Ride On. Don't need the mess.
Just air …. and I'll deal with any punctures when they are found. Most all of my valve stems now are metal.