Here is my solution to the no see um turn indicators. Installed this PM. Bought a Pilot red Glo-Pods 2 piece kit at Pep boys, cost of $23 for the pair. Part # CZ252R They are super bright, 6 leds on each oval pod.
Installation was as follows. Attached led pods to lower inside mirror housing, on each side, with velcour. Next task is splice into the turn signal wiring. Since the original factory wire has only 2 in. or so slack, you need to splice in an extension wire. I did ask Jeff Vey WHY the wire is so short, his response does not bear repeating. (totally BS).
You will need to break away the mirrors to access the short wires. Remove amber lens. I drilled a tiny hole in bottom of mirror housing to route the led wire inside. Be careful, the led wire needs to be attached to correct wires, or they will not work. It is also a tiny, fragile wire, solder and heat shrink everything. A bit of wire is on bottom of mirror housing, but my Baker wings hide it pretty well. Reattach the mirrors. A bit of KY on the posts helps a lot.
Result, turn signal LED indicators are quite visible in bright sunlight.
TBMS could fix this design defect if they wanted to. Maybe some better engineers would be a start.:yes: