I have a 2018 Vanderhall Venice. The seat back is fixed and can not tilt. I want to tilt it a little more upright. I was planning to remove the seat rails (bolted to the floor) and putting a spacer under the rear screw location, which would tilt it forward and up somewhat. Has anyone got any ideas on this?
I have figured out the only way to access the rear bolts is to align the seat/back gap over the screws, then use a long straight hex wrench (allen wrench) to reach down through the gap to unscrew it. There is no room under the seat to get any kind of wrench on the screws because there is no room between the screw head and the underside of the seat. Anyone know what size hex I need, since I have to go buy one? I can only eyeball it, and assume it is metric.