https://www.customdynamics.com/dynam...-trike?cat=818
My dealer service department is giving me grief over installing my DK driving lights and LED turn signals on my trike.
Backstory is my Passing lights which I connected the driving lights into quit working so I asked them to look at it when I took it in for some other warranty work.
They essentially came back and insisted that it was because of me installing the driving lights and turn signals and tapping into the passing and turn signal circuits with positaps.
Now this is the third time they have argued with me over 3 different issues.
1. Will a Tri-Glide start while in gear. Had to call corporate to get them to believe it should
2. The handle bars that I ordered through their parts department will not fit. Took 2 days to get them to install them after myself and the parts guy verified with manufacturer that they would fit.
3. The Passing light now not working.
Three Strikes.
So I have fired them and will be using another dealer for service that is closer to me. Made sure the Service manager knew this when I left.
I will continue to use there Sales and Parts department when it is convenient for me. Never had a problem with them.
I know the fairing harness has been repaired by them at least twice shortly after I bought the trike so I suspect the harness is probably bad as well as possibly the BCM.
The harness came from the factory having been pinched or scraped with bare wiring showing in 2 different areas near where I tapped in with the lights.
So if I do repair the harness and BCM I thought I would try the Dynamic Load Isolator to help keep this from happening again.
Any input would be helpful
Thanks
Bob