I try to check all of the important bolts, nuts etc on my trike at least every couple of months or so. Those of you that have checked the tightness and torque on the left front rubber, do you go to the trouble of removing the floor board mounts etc to get a clear shot to the allen bolt? I have a good size 3/8 allen wrench that will work if I cut about 1/4 inch or so off the short end. Of course I can't check torque with this but I think this would work just for routine checking. All of my other motor mount bolts I can get to with little trouble. Of course the two for the top mount are a little difficult, but doable. As you know, you can't get a socket wrench allen in the space that is provided for the left snubber. Any other ideas?