I know I have seen a thread on this but......
How does one slow the blinkers down after installing LED's? The bike is a 2016, replaced the directions with Custom Dynamics and led bulbs in the rear.
Thanks guys.
I know I have seen a thread on this but......
How does one slow the blinkers down after installing LED's? The bike is a 2016, replaced the directions with Custom Dynamics and led bulbs in the rear.
Thanks guys.
From Their Web Page
Custom Dynamics® Technical BulletinTurn Signal Sync on H-D BCM ModelsQuestions? Call us at: 1 (800) 382-1388 M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST07-2016TECHSome Harley-Davidson models equipped with canbus/BCM electrical systems while installing Custom Dynamics® LED turn signals in place of incandescent bulbs, will need to per-form a turn signal sync so that the product will function properly with the system.1.Turn Ignition on, but do not start the bike.2.Turn on 4 way hazards by pressing the hazard button on the controls. Turn Signal Sync Procedure3.Turn the Ignition off letting hazards run. IF the bike has security they will flash 5 or 6 times and then pause. This is normal. They will go back to flashing normal hazard mode.4.Let hazards run 1-2 minutes.5.Turn Ignition back on.6.Turn off hazards.7.Turn Ignition off and then back on.8.Check function of both turn signals.Note: Follow the instruction above. DO NOT press both turn signal switch's at the same time. That is the way the hazards activate on PRECANBUS bikes.
Nuff Said," Were Burnin Daylight, Lets Ride"(Sober 37 years)
Current ride : 2021 FREEWHEELER M8, oldest ride 1960 FL
Get a blinker that works off a timer rather than off of a load. There are many brands made for led applications. Mine was about $12 from eBay.