Hi, About one year ago, with a lot of "requests" from my Wife, I purchased/installed a set of RIVCO Passenger Armrests on our 2014 Tri Glide. The armrests are solidly built with a "second to none" mirror chrome finish. Both armrests pivot outward when getting on/off the Trike and are held in place by rear "screw-turn" tension bolts and attracting magnets mounted to the inside of the armrest's mounting bracket. When traveling at higher speeds, the only problem I have with the armrests is the screw bolts' tension and magnets' attraction, located at the rear of the armrests, are not strong enough to hold the armrests in place due to the forward portion armrests' vibration created when traveling with no passenger and their lack of arm placement used to keep the armrests in place.
This results with the oncoming wind catching each armrest and pivoting them to the rear near the Tour Pak. After consideration, I have thought about braiding/weaving some paracord/leather stripping using medium bracelet fasteners to secure their ends to the Trike's passenger seat hand rests and the RIVCO chromed arm rest extensions near the arm rest pads to keep the RIVCO armrests in place when traveling with no passenger. Does anybody have any additional suggestions?