Not sure about a pre made kit. My friend is in the business of wrapping cars with it, all the installations he does they cut on site from rolls and they do a great job. I'm going to have him wrap my new trike with clear and wrap my trailer with red film to match the trike.
My 14 Tri came with Expel clear bra installed (found the receipt in the tour pak ... installed 10/2019. Looks like new to this day. I had a small "dent" in the fender lower right where I'm guessing a small rock or big bug got it. Didn't touch the paint. I called Expel's number on the receipt to see if their lifetime warrantee extended to me. They said to give it a couple weeks to see if it "healed" itself. If it didn't, call them again and they would replace that fender's covering.
The stuff is amazing. It did "heal" the little dent. But, what I like most about it is that I know it's there and I can't hardly see it. Nobody notices it unless I point it out.
When I did the ceramic paint coating, I went right over it, just made it more shinny like the paint ... LOL. I did call Expel and McKey's 37 (makers of the ceramic) and both said it would work great, it did.
So basically, it comes down to what you like the look of best. I'm not gonna presume to know what's in your heart. But, since you asked for advice, I'll tell you what's in mine .... .
That's a gorgeous trike. The red poops. I wouldn't cover an inch of it. I think I would just put some ceramic paint sealer on it and call it a day. That stuff is amazing.
Here's an example. Your trike is not "weathered" like my truck was, but, it will give you an idea how good this stuff works (the ceramic).
Right side has the sealer, left side just cleaned.
Yeh I think for now I'm just going to leave the fender bra's off and run the clear film and see how it holds up. If in the future it starts looking bad I can install the bra's over it.
Hello,
I'm thinking of adding the ground effects foot board to my trike. I have the same full length fender bra. The pic appears to show a gap between the floor board and the fender. Is that correct? Can the bra be removed without messing with the ground effects floor boards? I've seen other posts that indicate that it can be challenging.
Thanks!
I doesn’t look like anyone makes an actual clear bra kit for a 2019 Gold Wing/CSC Trike conversion, so it would have to be custom. Besides covering (protecting) the front of the rear fenders, is there any other vulnerable areas that I should have clear bra material installed i.e., front fender?/front fairing?/ground effect kit?/fender area behind rear wheel?
Thanks,
Jim