Alright , I’ll try ;
First thing I did was took a picture as is , so the colors went back into the same slot.
Move a wire in and out on the connector and you should see a small tit lock on the wire end in the connector.
I used a small paper clip , making the end flat with a hammer turning it into a flat head screwdriver .
Stick it in the connector between the tit and connector then pull out the wire with the end attached.
Assemble by pushing the wire connector in ,you will hear a locking snap.
Take note as to what side the tit end goes back into the connector.
That step takes the longest in the bar change . Good luck .🍀👍 You can doooo it