06 Harley Ultra Classic True duals underneath with side boards, would they fit ?

[ricogomez]

06 Harley Ultra Classic True duals underneath with side boards, would they fit ?

Hell Forums, just wondering if anybody have a belt driven Lemans trike with floor boards

with true duals going underneath instead of the other type that goes over to the left side ?

I would prefer the change it to put the extra heat at the bottom, my wife's left leg gets too hot.

 

[rhino 2]

Rico.......Welcome to Trike-Talk.....:clapping:.....I can't help on the true duals.....But i'm sure someone will chime in soon with the answer....

 

[Lee H. Mann]

Rico, Welcome to Trike Talk from West Virginia.:wave4:

The back cylinder head pipe usually sweeps out the left side on a tru-dual exhaust.

You could probably take a set of Long Shots and make a system that looks similar to the 2009 and later.

If you have HOG EFX boards, you may have clearance issues at the rear.

A competent motorcycle shop should be able to help you and it would probably be a good winter project too.

Jim

 

[Jack Klarich]

Welcome to Trike Talk

Here is what the left side of a Harley bagger with true duals looks like

Keep in mind these systems are not cheap, good luck in your search

 

[ricogomez]

Thank You members your ideas and comments are all very much welcome,

For the rear cylinder we have one like in the last picture, but I was wondering if

the other type of head pipes true duals where the front head pipe go across the

the bottom to the passenger side would work ?

our Trike has the leman’s floor boards installed.

Thank You

 

[Jack Klarich]

Thank You members your ideas and comments are all very much welcome,

For the rear cylinder we have one like in the last picture, but I was wondering if

the other type of head pipes true duals where the front head pipe go across the

the bottom to the passenger side would work ?

our Trike has the leman’s floor boards installed.

Thank You

It could be done by any good exhaust shop ( provided they have a good welder) but, that is not the definition of true duals to a purest

 

[ricogomez]

I looked at the S & S true duals with individual head pipes,

but they are a bit expensive at the moment, around $450.00

on eBay and I don’t have the funds right now.