LED Bulbs For Rear

[priell3]

Has anyone switched the tail/brake 3157 bulbs to LED and what did you use as the replacement?

[Jack Klarich]

I use Sylvania super bright 3157 R on mine https://www.sylvania-automotive.com/...3157r_zevo.jsp

You will probably throw a code, do not panic. Clear the code, then turn on 4 way flashers for a couple of minutes. This gets the can bust to recognize the voltage difference

Do this before starting the bike, this should stop it from throwing a code to begin with.

Turn the ignition on

Turn on the hazards

Turn off the ignition and let the hazards run for 30 seconds or so.

Turn the ignition back on

Turned off the hazards

[My Turn]

I am using the same bulbs along with the custom dynamics flasher module. Works fine, brighter than stock,, and no codes.

[MDO]

Has anyone switched the tail/brake 3157 bulbs to LED and what did you use as the replacement?

Mike, here is the link to the thread where I outlined replacing mine on my 2017 FW.

https://www.triketalk.com/forum/thre...aillight+bulbs

[priell3]

I went with these from Amazon. Delivered and installed today. Look good an much brighter.

AmazonSmile: AUXITO 3157 LED Reverse Light Bulbs, Extremely Bright 3030 Chipsets 6000K White, 3056 3156 3057 4157 4057 3457 LED Replacement Lamp for Backup Reverse light, Tail Brake Signal Lights: Automotive

[priell3]

Full LEDs.