I can't seem to find a plug and play resister. I put on LED rear and front turn signals. Anyone know where I can find a solution without splicing wiring? Not a fan off the inline resister as they get HOT.
I can't seem to find a plug and play resister. I put on LED rear and front turn signals. Anyone know where I can find a solution without splicing wiring? Not a fan off the inline resister as they get HOT.
Try turning your 4 way flashers on for a few cycles, The Freewheelers have the can bus system, no need for an additional resistor
Doing this gives the BCM time to adjust
When done, scan your ECM for trouble codes, write them down before clearing them
This should solve your problem
Follow this link for reading and clearing codes
https://www.appletonhd.com/harley-da...trouble-codes/
Nuff Said," Were Burnin Daylight, Lets Ride"(Sober 37 years)
Current ride : 2021 FREEWHEELER M8, oldest ride 1960 FL