I have a 2019 Freewheeler, and installed some 16 inch apes, and had trouble getting wiring through the bars. Bottom line: got a little rough with the wires, and I’m sure there were some places where insulation was worn off. Lesson learned. Anyway, I didn’t have the bars quite tight enough, and when I hit some railroad tracks really hard, bars dropping a couple of inches, and now I’ve got electrical problems.
Installed new wiring, and now all that works is all the lights (come on only) and gas gauge light. NOTHING else works. All of the fuses check out good, but I don’t know how to test the two relays in fuse box. Could something other than a fuse get fried? Also, does the heated grip wiring on throttle by wire setup need to be hooked up to start/run? Thanks, Ed