Well here is one for ya. While on vacation my 2001 Ultra had the most nasty noise from the breaks. The shop that I stoped in was good enough to look at the bike right then and there. The folks at Sevier County Choppers were up front with me and told me that they had no experience with trikes, but would do what they could to help. It was deduced that the emergency break was making all the noise. He did his best to adjust them so the rattle would go away, no luck. So, I had him take them off the bike. No more noise, no more emergency break either. Along with that it was found that the pins holding the pads into the calipers on the main breaks had been replaced with very high quality clothes hanger wire. Now, I know that clothes hanger wire can do almost as much as duct tape, but I dont think holding the breaks in place is one of them. When I called lehman I was in contact with a person who did not seem like he was up to snuff on the breaks on older trikes. So...my questions are this.....Is there some kind of clip, or spring steel that goes on behind the emergency break pads to keep them from chattering? As for the other thing, I think I will go down to my local auto shop and see if there is another set of pins that will fit. The guy working on the trike thought that the pins were only for those calipers. I ask lehman both times I talked to them to e-mail me the info with pics on the breaks. Guess they were unable to do that. The local lehman dealer is not to far away, I am also going to go there and have a chat with them.