I had written in an earlier thread about my Rekluse clutch. Here is what happened. I was going to have it installed at an independent shop recommended by the H-D dealer where I bought my TG. It was 140 miles from my house so I decided to get it at the local H-D shop so if there was any repairs needed I would be nearby. I asked them ahead of time if they knew how to install it. They stated that they did, so I proceeded with the purchase. When I went to pick up the trike they didn't give me any instructions about how to shift it or anything. They said "you'll figure it out". I seemed okay for about 350 miles on a couple of trips. I was on a trip to a city about 130 miles from home when it seemed to be slipping. I took it to the H-D dealership there and had it adjusted, it seemed okay after about another fifty miles it started the slipping again. This happened a couple of more times so I am feeling something is really wrong with the installation. Now I'm by the original dealer where I bought the trike and I was told they would not work on anything Non-Harley and recommended I take it to the independent that I was originally told to go to. The dealer called them where upon I was told they could do it but not this day. They were swamped, I said give me the address and I will go beg. Here I am stranded 130 miles from home and it will barely move. I got it there and "begged". Mark said he would take a quick look and see if he could get me going. After about two hours he said it needed to be replaced because it wasn't installed correctly. I had spoken to Rekluse several times prior to this episode, so now I's stuck. Friday afternoon and what do I do. I, called them and spoke to Tony in tech support and asked for Danny who I had been dealing with. Tony told me he would call Danny and get back to me. Finally he called and said they were shipping and new clutch over-night with Saturday delivery. Conclusion, it is in and working like it supposed to. This is huge thank you to Rekluse for their great customer service.