Rear bumper for a 2012 CSC

[paid4c4]

I have a 2012 Honda Goldwing which is a CSC trike. I recently saw a CSC with a really nice rear bumper. I didn't get to talk to the rider so I don't if he had it built or if CSC might have built it. My question is does CSC build rear bumpers for my trike?

Thank You;

Bill

 

[cScjhb]

I don't want to sound too obvious, but, I would contact CSC and ask..... Jim

 

[Bronson512]

I have asked CSC that very question 2 times to be exact. Once on this forum. Check a few post down and you'll get their answer. Even though those guy are smarter than I am and after looking at my CSC I cannot for the life of me figure out why they cannot come up with something that will fasten in the receiver that would at least protect against the inadvertent bumps, scraps and broken lenses etc. it doesn't have to pass the government 20 MPH crash test. I really think they are missing the boat. There is at least one mfg that makes a very nice looking bumper for their trike.

 

[paid4c4]

I have asked CSC that very question 2 times to be exact. Once on this forum. Check a few post down and you'll get their answer. Even though those guy are smarter than I am and after looking at my CSC I cannot for the life of me figure out why they cannot come up with something that will fasten in the receiver that would at least protect against the inadvertent bumps, scraps and broken lenses etc. it doesn't have to pass the government 20 MPH crash test. I really think they are missing the boat. There is at least one mfg that makes a very nice looking bumper for their trike.

I also spoke with CSC and they don't offer a rear bumper. I have found a source of flat steel stock which would fit into the trailer hitch receiver. I think it would be easy to fabricate a rear bumper have it welded and powder coated. I'll post something if I take this on as a project.

Bill

 

[Bronson512]

I also spoke with CSC and they don't offer a rear bumper. I have found a source of flat steel stock which would fit into the trailer hitch receiver. I think it would be easy to fabricate a rear bumper have it welded and powder coated. I'll post something if I take this on as a project.

Bill

I'll be watching!