Nice, how long is the shaft?. ...I like it
11 1/4 center to center on the u-joints ! That is with 1 1/4 of spline pulled out. That should be plenty of travel for my application.
Nice, how long is the shaft?. ...I like it
Great to see some more forward progress on your trikeThumbUp
Are you setting it up more for the drags, or street?
Looks & sounds good with the turbo spoolin'!
The rear pinion won't be 10 degrees off. As I stated earlier, I cut the saddles off of the rear axle to allow me to roll the differential/pinion to an upward angle to match the angle of the engine/transmission. The offset to allow the u joints to work will be handled by the pinon shaft which is not dead center on the axle.